Step 6: Cpu Card Installation; Step 8: Disk Drives Installation - Acnodes RMC8416 Installation Manual

Step 3: Once the backplane is properly aligned with the
retention screw holes, insert retention screws in all the
retention screw holes in the backplane to secure the
backplane to the chassis.
Figure 10: Insert Backplane Retention Screws

STEP 6: CPU CARD INSTALLATION

To install the CPU card please follow the instructions
below:
Step 1: Remove the slot cover at the front of the chassis.
To do this, remove the slot cover retention screw at the top
of the slot cover.
Figure 11: Remove the Slot Cover Retention Screw
Step 2: Slide the CPU card into the socket on the
backplane reserved for the CPU card. If you are installing a
full-size CPU card, make sure the back edge of the CPU
card slots into the corresponding plastic guides located
behind the cooling fans.
Step 3: To secure the CPU card, reinsert the previously
removed slot cover retention screw.
STEP 7: PCI/ISA EXPANSION CARD INSTALLATION
The RMC 8416 supports up to 13 PCI/ISA expansion
cards. To install an expansion card (PCI or ISA) please
follow the steps below.
Step 1: Remove the slot cover at the back of the chas-
sis. To do this, remove the slot cover retention screw at
the top of the slot cover.
Step 2: Slide the PCI/ISA expansion card into reserved
PCI/ISA socket on the backplane.
Step 3: To secure the PCI/ISA expansion card,
reinsert the previously removed slot cover retention screw.

STEP 8: DISK DRIVES INSTALLATION

The RMC 8416 chassis has 2 drive brackets: a main drive
bracket and a side bracket. To install the drives, please
follow the steps outlined in the sections below.
STEP 8.1: REMOVE THE SIDE BRACKET
Before any drives can be installed, the side bracket
attached to the main drive bracket must be removed. To
remove the side bracket, remove the 2 retention screws
from the top of the side bracket that secure the side
bracket to the main bracket.
Figure 12: Remove the Side Bracket
5