Step 12: Cover Reinstallation - Acnodes RMC8416 Installation Manual

Figure 20: Hold-Down Clamp Retention Screw Holes in the
Clip of the Side HDD bracket
Step 3: Reinsert the 2 hold-down clamp retention screws.
Step 4: Press the rubber of a shock absorber with proper
length against the top of the PCI/ISA card you want to
secure, according to the height of the installed PCI/ISA card.
Step 5: Align the retention screw hole in the shock
absorber with the corresponding retention screw hole in the
hold-down clamp.
Step 6: Insert one retention screw for each shock
absorber to secure it to the hold-down clamp.
Figure 21: PCI/ISA Card Shock Absorber

STEP 12: COVER REINSTALLATION

After you have completed the above procedures, the cover
can be reinstalled. To do this, slide the cover back over the
chassis and reinsert the 6 previously removed retention
screws.
There are three 8 cm cooling fans inside the RMC 8416
chassis. To replace a fan, please follow the instructions
below:
Step 1: Loosen 2 thumbscrews for the fan that must be
replaced.
Figure 22: Locations of the Fan Bracket Thumbscrews
Step 2: Unplug the power cable that is connected to the
fan.
Figure 23: Unplug the Fan Power Cable
Step 3: Remove the fan by removing the four fan retention
screws.
9