Removing Associations From The Receiver; Radio Quality Test - DELTA DORE Tybox 1137 Installation And User Manual

11.2 Removing associations from the receiver

Hold down the button to remove the radio associations from the receiver.
1
> 3s
A
: The red LED flashes after 3 seconds.
The receiver is in pairing/association mode.
: If you continue holding down the button, the red LED flashes quickly after 10 seconds.
The receiver is waiting to remove the association with an opening detector or a booster (check on the device you
want to unpair).
: If you continue holding down the button, the red LED turns off after 20 seconds.
All associations with the receiver are now removed.
: If you continue holding down the button for 30 seconds, the LED flashes 3 times.
The receiver is fully reset (back to factory settings).

11.3 Radio quality test

This mode helps you check the radio quality between the transmitter and the receiver.
2
>5s
1
❶ Turn the dial on the transmitter
to , then press the i button for 5
seconds (❷).
❸ Briefly press R button once.
The display shows rAd.
> 10s > 20s
B
4
3
>3s
❹ Press OK for 3 seconds until the
display shows "tESt".
❺ The number shows the
transmission quality percentage
< 30
from 30 to 60
> 60
If the number is too low, move the
transmitter closer to the receiver
or add a repeater (booster) to your
installation.
> 30s
C
5
6
EXIT
❻ To exit the mode, turn the dial.
Weak
OK
Good
D
12