Table of Contents
Advertisement
Battery Replacement
IMPORTANT: Before replacing the battery ensure the heater is isolated from the
electricity supply. NOTE - Battery should be disposed of in an appropriate manner
This product is fitted with a replaceable battery in the controls.
To replace the battery, follow the steps below, shown in Fig. 6:
1. Unhinge the heater from the wall using the clips shown in Fig. 2 and locate
the battery module.
2. Slide the catch and pull module from the controls.
3. Remove the coin cell battery and replace.
4. Slide module back in place, ensuring clip is engaged.
Important
During initial heat-up, some odour may be emitted due to the newness of materials
used in manufacture. This is normal and will disappear after a short period of use. It is
however advisable to keep the room well ventilated.
Cleaning
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
Before commencing cleaning, isolate the heater from the electrical supply and allow it
to cool. The outside can be cleaned by wiping it over with a soft dry cloth. Do not use
abrasive cleaning powders or furniture polish, as this can damage the surface finish.
To release the heater from the wall bracket for cleaning or redecoration, depress the
latch on both brackets (See Fig. 2) and hinge forward.
1
2
3
4
Battery positive side up
Fig. 6
23
Advertisement
Table of Contents
