Further Installation On The Cylinder Module; Aligning The Cylinder Module At The Installation Site - Viessmann Vitovalor PT2 Installation And Service Instructions For Contractors

Installation sequence
Installing and aligning the Vitovalor PT2

Further installation on the cylinder module

The angle connector is supplied in the "Tower cylinder
connection set" box.
4x
1.
4x
4.
Fig. 24
1. Fit the angle connector on the cylinder module.
2. Fit the supplied edge protector to the opening for
electrical cables.
3. Route 2 cables with plugs
cylinder module. Insert cables at the back of the
gas condensing and fuel cell module.

Aligning the cylinder module at the installation site

Fitting accessories
Check prior to the final positioning whether all acces-
sories mounted from the back have been added. E.g.
connection set and (if available) DHW circulation con-
nection set
34
(cont.)
4x
3.
2.
and out of the
jF aBH
4. Stick the spacer to the corners and in the middle of
the side panel.