Installation sequence
Making the hydraulic connections
Connect heating water flow and heating water return at the heat pump
!
Please note
Mechanically loaded hydraulic connections lead
to leaks, vibration and appliance damage.
■
Connect supplied connecting hoses (bends)
so that they are free of load and torque stress.
■
To prevent transmission of any vibration, the
connecting hoses must not contact any other
components.
2.
2x
1.
3.
A
B
C
Fig. 8
Heating water return
A
Heating water flow
B
Hydraulic connection set (accessory)
C
Connect heating circuits and DHW cylinder in the building
1. Equip the secondary circuit on site with an expan-
sion vessel and safety assembly (in accordance
with EN 12828).
Fit the safety assembly to the on-site line in the
heating water return.
2. Connect secondary lines to the lines of the
hydraulic connection set (accessory).
!
Please note
Mechanically loaded hydraulic connections
lead to leaks, vibration and appliance dam-
age.
Connect on-site lines so that they are free of
load and torque stress.
16
A
B
4.
Note
The connecting hoses can be shortened.
■
■
Completely encase connecting hoses in the supplied
thermal insulation.
!
3.
Please note
Leaking hydraulic connections lead to appli-
ance damage.
Check the tightness of the internal and on-
■
site hydraulic connections.
■
In the event of leaks, drain off liquid via the
drain valve. Check the seating of seal
rings. Always replace displaced seal rings.
Observe information regarding filling and venting:
See page 51.
4. Thermally insulate pipes inside the building.
5. Connect the drain hose to the safety valve.
Connect the drain hose to the public sewage sys-
tem with a fall and a pipe vent.