Table of Contents
Advertisement
SECTION 5 – MAINTENANCE SCHEDULE AND SERVICE PROCEDURES
Service Procedures (cont.)
ENGINE OIL AND FILTER (cont.)
10. Lubricate new oil filter gasket with clean engine oil.
CAUTION: To prevent engine damage, install the correct oil filter
for the engine application.
11. Install new oil filter.
•
Standard oil filter (long)
•
Front drive/steering axle oil filter (shorter)
CAUTION: To prevent engine damage, do not overtighten filter.
12. Hand tighten filter 2/3 to 1 full turn after gasket first contacts
oil filter header.
CAUTION: To prevent engine damage, do not overfill with oil.
13. Add engine oil with the correct oil viscosity and formulation.
API CJ-4 oil is recommended but CI-4 is allowable. Use of
CI-4 oils will reduce DPF cleaning interval, see Maintenance
Schedule (page 59). Add oil through the engine oil fill tube.
Figure 32 Oil level gauge (typical)
14. Check oil level gauge.
crosshatched operating range.
15. Start engine and run at low idle.
16. Check reading on oil pressure gauge.
•
Minimum lube oil pressure is 214 kPa (31 psi) minimum
@ 700 rpm.
•
If there is no gauge reading, shut engine down
immediately. Check for oil filter leaks.
•
Let engine run until operating temperature is reached.
Check for leaks.
17. Shut down engine for 15 minutes.
CAUTION: To prevent engine damage, do not overfill with oil.
18. Recheck oil level and add oil to bring oil level within the upper
half of the crosshatched operating range on oil level gauge.
CENTRIFUGE FILTER (IF EQUIPPED)
Service Interval (based upon fuel consumption and specific
engine application):
Form No. 1172040R1
Printed in the United States of America
Oil level must be within the
Page 73
Hide quick links:
Advertisement
Table of Contents
