Natural Gas Conversion - Kenmore W11024188A Installation Instructions Manual

Hide thumbs

Table of Contents

Available languages

4. Apply masking tape to the end of a 3/8" (1 cm) nut driver

to help hold the gas orifice spud in the nut driver while

changing it. Press nut driver down onto the gas orifice

spud and remove by turning the Natural gas broil burner

orifice hood counterclockwise to remove. The hood will be

stamped with a "155."

5. Replace the "155" hood with a "100" hood. Install the

propane broiler burner orifice hood, turning it clockwise

until snug.

IMPORTANT: Do not overtighten.

A. Orifice hood

6. Place the broil burner on the broil burner orifice hood.

Insert the broil burner ceramic igniter in the hole in the

rear of the oven.

7. Replace the flame spreader with all 4 tabs facing up

and the notches toward the rear of the oven.

8. Position the broil burner against the top of the oven

and attach it with 1 screw.

9. Replace storage drawer. See the "Remove/Replace

Drawer" section.

10. Replace the oven door. See the "Oven Door" section.

11. Replace the oven racks.

Complete Installation (Natural Gas to Propane)

1. Refer to the "Make Gas Connection" section for proper

connection of the range to the gas supply.

2. Refer to the "Electronic Ignition System" section for proper

burner ignition and operation.

3. Refer to the "Adjust Flame Height" section for burner

flame adjustments.

IMPORTANT: You may have to adjust the low setting for

each cooktop burner.

Checking for proper cooktop flame is very important. The

small inner cone should have a very distinct blue flame

1/4" to 1/2" (0.64 to 1.3 cm) long. The outer cone is not as

distinct as the inner cone. Propane flames have a slightly

yellow tip.

4. Refer to "Complete Installation" in the "Installation

Instructions" section of this manual to complete this

procedure.

IMPORTANT: Make sure to save the orifices that have

just been replaced in the conversion.

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation

instructions.

Slide range back so rear range foot is engaged in the

slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed

and engaged.

Failure to follow these instructions can result in death

or serious burns to children and adults.

1. Turn the manual shut-off valve to the closed position.

2. Unplug range or disconnect power.

To Convert Gas Pressure Regulator (Propane

to Natural Gas)

1. Remove the storage drawer. See the "Remove/Replace

Drawer" section.

2. Locate gas pressure regulator at rear of the drawer

compartment.

IMPORTANT: Do not remove the gas pressure regulator.