Kenmore W11024188A Installation Instructions Manual page 15

3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a
5/8" (1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
A
B
C
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
"ê LP" is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas
to Propane)
1. Remove burner cap.
2. Remove the burner base.
A
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
C
X-Large Burner
A. Burner cap
B. Burner base
C. Choke (for use with x-large burner, propane
only)
Side view before
D
E
Side view after
B
C
D
A
B
3. Apply masking tape to the end of a 9/32" (7 mm) nut
driver to help hold the gas orifice spud in the nut driver
while changing it. Press nut driver down onto the gas orifice
spud and remove by turning it counterclockwise and lifting
out. Set gas orifice spud aside.
B
A
C
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4. Remove the orifice spuds shipped in the literature package
in the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
propane orifice spud.
A. Propane groove
Refer to the following chart for correct propane orifice
spud ratings and to spud holder card for proper placement.
Fully insert choke into bottom of X-Large burner base.
Choke should snap into place.
NOTE: Use only for spreader bases marked "XL."
Propane Orifice Spud Chart for Surface Burners
Burner Color
Rating/Type
15,000 BTU/ Silver
Stacked* Black/Orange
14,200 Silver
BTU/Ultra/
Stacked*
8,000 BTU/ Red/Orange
Semi
5,000 BTU/ Red/Blue
Auxi
1,200 BTU/ Black/Orange
Stacked/
Simmer*
* Not in all kits/models
NOTE: Refer to the model/serial/rating plate located on the
oven frame behind the top left-hand side of the oven door for
proper sizing of spuds for each burner location.
5. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case
of reinstallation with Natural gas.
6. Replace the burner base.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
D
A
Size ID Placement
(mm) number
1.05 L105 LF
0.32 L32
1.05 L105 RF
0.85 L85 RR/CTR
0.65 L65 LR
0.32 L32 LF
(Simmer)
15