Daikin FTXZ25NVM Operation Manual page 45

Display
Case
The air conditioner is operating
even with the OPERATION lamp
off.
The indoor unit lamps are dark.
When operation is started, the
OPERATION lamp blinks for a
while and then lights up.
The TIMER lamp blinks.
The MOLD PROOF / CLEANING
FILTER lamp blinks.
The MOLD PROOF / CLEANING
FILTER lamp blinks even after the
dust box is cleaned.
FLASH STREAMER AIR PURIFYING operation
Case
There is a sign of burning on the
metal section of the streamer unit.
FLASH STREAMER AIR
PURIFYING operation cannot be
performed.
The sound of streamer discharge
stopped.
CLEANING FILTER operation
Case
CLEANING FILTER operation does
not function.
CLEANING FILTER operation does
not stop.
[MOLD PROOF / CLEANING
FILTER lamp is off]
The air fi lter gets stuck during
CLEANING FILTER operation.
A large noise occurs in CLEANING
FILTER operation.
The air fi lter is still dirty even after
CLEANING FILTER operation is
performed.
Description / where to check
• Is the brightness of the indoor unit lamps set to "Off"?
• Is the brightness of the indoor unit lamps set to "Low"?
• Check the error code and consult the service shop.
• Clean the streamer unit.
 Page 36
• Clean the dust box.  Page 37
• Reset the dust box cleaning indicator. If the MOLD PROOF / CLEANING FILTER lamp still
blinks, consult the service shop.
Description / where to check
• This is a sign of streamer discharge and normal.
• Is the front panel open?
Close the front panel.  Page 35
• Is the streamer unit securely installed?
• Is the needle tip of the streamer unit dirty?
Clean the needle.
 Page 36
• Streamer discharge stops when the indoor temperature becomes close to the set
temperature and the airfl ow rate decreases.
Description / where to check
• To protect the air fi lters, CLEANING FILTER operation is not performed when the indoor
temperature is 10°C or lower.
• This happens when the MOLD PROOF / CLEANING FILTER lamp is blinking. Clean the
dust box and reset the dust box cleaning indicator.
„ After the operation has been stopped manually
• The air fi lter is moving back to the normal position. Wait for up to about 3 minutes.
• Check to see whether the fi lter section of the air fi lter is not deformed.
• Check to see whether the air fi lter, photocatalytic air-purifying and deodorising fi lter, and
dust box are properly attached.
If the fi lter section of the air fi lter is deformed, consult the service shop.
• Is there too much dust in the dust box?
• Grease and tar from tobacco may not be removed completely. Clean the air fi lter.
 Page 10
 Page 10
 Page 40
 Page 29
 Page 37
 Page 37 - 39
 Page 37
 Page 38
44 44