Table of Contents
Advertisement
No.
Menu
Setting
Push APPLY
2 sec.
RC
9
ADDRESS
Push APPLY
2 sec.
< Note >
• This function sets the address when you install 2 indoor units in the same room and do not want to operate them with 1 remote
controller.
When you set one of the indoor units and one of the 2 remote controllers to "2", the set remote controller can send a signal only to
the set indoor unit.
The default setting is "1" for both the indoor unit and remote controller.
< To set the address to "2" >
1. Open the front panel, and turn on the circuit breaker.
2. Press
.
1 *
3. Press
to select "RC ADDRESS" and press
4. Press
to select "2".
5. Press
for 2 seconds and send a signal to the indoor unit. The OPERATION lamp
(green) blinks for about 1 minute. (This is not an error blink.)
6. Press the indoor unit ON/OFF switch while the OPERATION lamp is blinking.
2
Description
.
If you cannot set the address while
the OPERATION lamp is blinking,
redo this procedure from the first step.
* Default setting
34
Advertisement
Chapters
Table of Contents
