Memory Usage - Cabletron Systems CyberSWITCH CSX5500 Release Note

H0 Calls:
H0 Calls are not supported on NET5 switches.
Solution:
The initial configuration to enable H0 calls for users must be done in CFGEDIT. Subsequent
changes may be made in either Manage Mode or CFGEDIT.
Any other problems than those listed above should be reported to our Technical Support Staff. See section titled
Global Call Support for contact information.

MEMORY USAGE:

Memory Requirements for UAA Release 7.4:
The UAA 7.4 software release requires a minimum 8 Mbytes of DRAM in the NE2000-II/4000/5000, and
32 Mbytes of DRAM in the NE7000 and CSX5500/6000/7000 platforms.
Notes:
1. The NE2000-II/4000/5000 platforms come equipped with 8 Mbytes of DRAM from the factory but
accept up to 12 Mbytes.
2. New CSX5500/6000/7000 platforms come equipped with 32 Mbytes of DRAM from the factory.
3. Older CSX6000/7000 platforms come equipped with either 8 or 32 Mbytes from the factory
depending on the date of shipment. Owing to the increased feature content, enhanced multi-protocol
support and increased connection capacity of UAA 7.4, customers planning to upgrade their existing
8 Mbyte platforms to UAA 7.4 may require a memory upgrade. Contact your Cabletron
representative for more information about 32 MByte upgrade kits.
4. The SmartSwitch 9W006 and 9W007 Remote Access Modules for the SmartSwitch 9000 come
equipped with 32 Mbytes of DRAM from the factory.
COMPLIANCE SUPPORT:
Compliance Issue
Year 2000
Leap Year
Millennium
IETF STANDARDS AND/OR RFC SUPPORT:
RFC No.
768 User Datagram Protocol (UDP)
791 Internet Protocol (IP)
793 Transport Control Protocol (TCP)
877 X.25
1157 SNMP
1321 MD5 Message Digest
1334 PPP Authentication
06/99 P/N: 9032577-02
F0615-C
Central Site CUSTOMER RELEASE NOTES
Approved
Yes
Yes
No
Title
Subject to Change Without Notice
35 Industrial Way
PO Box 5005
Rochester, NH 03867-5005
(603) 332-9400
7
Page: