Grizzly G0948 Owner's Manual page 57

Item(s) Needed
Precision Straightedge 3'. .................................. 1
Open-End Wrench or Socket 10mm ................. 1
Pencil or Marker ................................................ 1
To adjust lower wheel laterally:
1. DISCONNECT MACHINE FROM POWER!
2. Remove fence and table from machine.
3. Check wheels at A and B locations (see
Figure 73). The wheels should align.
— If wheels align, no adjustment is required.
— If wheels do not align, they require lateral
adjustment (see Figure 74). Proceed to
Step 4.
4.
Mark upper and lower wheels with a pencil or
marker to indicate measuring locations (see
Figure 73).
Note: Marking the wheels ensures more
accurate results in case there are irregulari-
ties in the wheels.
Upper Wheel
Straightedge
A1
A2
Lower Wheel
Figure 73. Example of using a straightedge to
check lateral wheel alignment.
Model G0948 (Mfd. Since 08/21)
Qty 5.
6.
7.
Straightedge
B1
B2
Loosen hex nuts on rear left and right adjust-
ment bolts (see Figure 72 on Page 54).
Rotate left and right adjustment bolts until
lower wheel is coplanar with upper wheel,
see Figure 74.
Viewed From Above
Requires lateral
adjustment
Straightedge
Figure 74. Before and after lateral wheel
alignment (viewed from above).
Tighten hex nuts loosened in Step 5.
After lateral
adjustment
-55-