Grizzly G0948 Owner's Manual page 19

2. Attach (1) short brace to (2) stand legs with
(2) M8-1.25 x 16 carriage bolts, 8mm flat
washers, and M8-1.25 hex nuts, as shown in
Figure 12. Only finger tighten for now.
Stand Legs
x 2
Figure 12. Stand legs attached to short braces.
3. Repeat Step 2 with remaining (1) short brace
and (2) stand legs.
4. Attach (2) leg assemblies together with (2)
long braces using (4) M8-1.25 x 16 carriage
bolts, 8mm flat washers, and M8-1.25 hex
nuts, as shown in Figure 13. Only finger
tighten for now.
Long Brace
(1 of 2)
Figure 13. Leg assemblies attached with long
braces.
Model G0948 (Mfd. Since 08/21)
Short
Brace
x 4
5. Have an assistant position machine base
over top of stand (see Figure 14), and secure
with (8) M8-1.25 x 16 carriage bolts, 8mm flat
washers, and M8-1.25 hex nuts.
x 8
Figure 14. Machine attached to stand.
6.
Ensure machine is level, side to side and front
to back, then tighten all fasteners installed in
Steps 2–5.
7. Remove (4) pre-installed M6-1 x 10 hex bolts
and 6mm flat washers from base of table, and
loosen (2) shoulder screws (see Figure 15)
securing trunnions to trunnion bracket.
Note: For operations requiring a high degree
of accuracy, tighten shoulder screws secur-
ing trunnions to trunnion bracket to increase
table rigidity.
8. Slide table past saw blade through table slot,
and secure table to trunnions with fasteners
removed in Step 7 (see Figure 15).
x 4
Figure 15. Table attached to trunnions.
Page reference 16
Shoulder Screw
(1 of 2)
Scale
Indicator
-17-