NetComm Videotron 3G39W-V User Manual page 24

Advanced Routing
This page allows you to configure static and dynamic routing rules for your 3G39W-V.
Advanced Routing – Static
Static Routing allows computers that are connected to your 3G39W-V to communicate with computers on another LAN segment
which are connected to it via another router. To set a rule, you need to specify the following:
Destination

Range – Select from Host (255.255.255.255) or Net (and then enter the appropriate subnet mask)

Gateway

Interface

Comment to identify the route entered (optional)

Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the 3G39W-V to adapt to changes in the network. RIP enables the device to
determine the best route for each packet based on the ‚hop count‛ or number of hops between Source and Destination. To enable
Dynamic Routing, select Enable from the drop box and click Apply.
DHCP Client List
This page allows you to view the current DHCP clients that have obtained IP leases from your 3G39W-V. The MAC address,
assigned IP address and the expiry period is shown for all computers who have automatically obtained addresses from the 3G39W-
V. Please note that this list is stored in the device's volatile memory, and is therefore cleared if the device is reset or if any changed
are applied to configuration.
YML39W-VX
www.netcomm.com.au
Figure 20 - Advanced View - Advanced Routing Settings
Figure 21 – Advanced View – DHCP Client List
Videotron – 3G39W-V
3G39W-V User Guide
24