Coolant Level Verification - PREVOST H3-41 Manual

Wheel Bearing Oil Level
The oil level for the front and tag axle wheel
bearings must be maintained to the level marked
in the cap. The oil level indicator, which is shown
as a line with arrows, is part of the plastic lens and
is located below the words OIL LEVEL. Wait at
least 15 minutes before checking the oil level after
the coach has been driven to make sure the
bearing oil has settled. Differential oil is used to
lubricate the drive axle wheel bearings. Maintain
the drive axle wheel bearing oil at the level
indicated to ensure adequate lubrication.
WHEEL BEARINGS LUBRICATION
CAUTION: THE WHEEL BEARING OIL FILL
CAP HAS A SMALL VENT HOLE IN THE
CENTER TO PREVENT OVERPRESSURE IN
THE BEARING HOUSING.
OCCASIONALLY BY INSERTING A NEEDLE.

COOLANT LEVEL VERIFICATION

Coolant level is correct when the cold coolant is
visible through the surge tank sight glass.
coolant level is low, fill cooling system with the
same 50-50 mixture normally used.
ENGINE COMPARTMENT
WARNING:
UNDER HIGH PRESSURE.
TO COOL DOWN BEFORE ADDING COOLANT.
OEH3B722
CLEAN
7-8
CARE AND MAINTENANCE
HOT ENGINE COOLANT
ALLOW ENGINE
If
OEH3B724
IS