Video System Remote Control - PREVOST H3-41 Manual

2nd memory: Press "
for the 2nd start time**; "
Illuminates.
3rd memory: Press "
is set for the 3rd start time**; "
Illuminates.
NEUTRAL POSITION: Press "
no display or display of present time*; no
preselected start time.
Setting Start Times**
Set start times as follows:
1.
1st memory: Momentarily press "
Illuminates.
2nd memory: Momentarily press "
Illuminates.
3rd memory: Momentarily press "
Illuminates.
2. Set start time by pressing "
Erreur! Les arguments du commutateur
ne sont pas spécifiés.".
NEUTRAL POSITION: Press "
no display or display of present time*, preset
start times still in memory.
* Eventually continuous display of present time
with the ignition key in ON position.
** Display of water heater start time turns off
after approximately 20 seconds, or switches to
the present time.
WARNING: THE
USES THE SAME FUEL AS THE ENGINE. DO
NOT OPERATE IN A BUILDING OR WHILE
REFUELLING. OPERATE
VENTILATED AREA.
" twice; heating is set
" three times; heating
" once again;
" ; "
" ; "
" ; "
" or
" once again ;
PREHEATING SYSTEM
IN A WELL-
IN CASE OF PREHEATING SYSTEM
MALFUNCTION:
C
"
1. Place heater switch to OFF position; then to
ON position.
D
" 2. Check main circuit breaker and overheating
switch.
3. Report problem to maintenance personnel.
22 - Lamp
Pivot the lamp cover upward to illuminate the
road map compartment, and pivot downward to
extinguish light.
23 - Road Map Compartment
B
"
Used to store road maps.

VIDEO SYSTEM REMOTE CONTROL

C
"
Depressing the VIDEO system power switch
located on the L.H. control panel will activate the
TV monitors, the TV converter and the video
D
"
cassette player.
NOTE: When both the radio and video system
"
are on, the speakers in the passenger area will
be connected to the video system, while the
speakers in the driver's area will be connected to
the radio.
The remote control power cord must be
connected to the video cassette player as shown
in figure 1.
FIGURE 1
3-7
CONTROLS & INSTRUMENTS
OEH3B312