Senco Fusion F-15XP Operating Instructions Manual page 22

Cordless finish nailers
Table of Contents

Advertisement

Problem/Symptom
Tool runs but will not drive
fastener.
Poor feed/ tool jamming.
Broken or worn driver.
Tool does not fully return.
Ensuring the long life of your Cordless Finish tool
Welcome to SENCO's family of products. SENCO brings 50 years of commitment to our customers and to power fastening
systems. We are dedicated to making sure your tools are performing at their best, and we understand that ensuring the
long life of your tools is important. Here are some operational and service tips.
• Start with fully charged batteries at the beginning of each work day.
• Set the depth of drive on your SENCO tool so fasteners are not over-driven.
• To maximize battery life, follow storage recommendations and charging recommendations in this manual.
• Keep your Cordless Nailer as clean and free of debris as possible.
• Service your SENCO tool periodically to insure your tool is productive and helping you earn money on the job.
See the service guide below for recommended service intervals.
If your Cordless Nailer does require service, dedicated SENCO servicing dealers are available for you. For the location
nearest you, call SENCO's Action line at 1-800-543-4596 or visit SENCO's website (www.senco.com).
Recommended service includes
• Check Electrical System
• Check Feed System
• Check Drive Track
• Add Grease to Piston and Driver
TROUBLESHOOTING
Probable Cause
Battery is discharged or has a
dead cell.
Nail jam in guidebody.
Mechanism requires repair.
Tool is overheated.
Driver tip not located above
fastener.
Debris build-up in mechanism.
Driver tip not located above
fastener.
Weak battery.
22
Corrective Action
Recharge or replace with fresh
battery.
Refer to operators manual for
jam-clearing instructions.
Return tool to authorized SENCO
service representative.
Allow tool to cool and insert fresh
battery.
Recharge battery and allow tool to
automatically retract driver.
Clean tool, clean magazine or
inspect feeder spring.
Return tool to authorized SENCO
service representative.
Recharge battery and allow tool to
automatically retract driver.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fusion f-16xpFusion f-18xp

Table of Contents