Senco Fusion F-15XP Operating Instructions Manual page 17

Whenever possible, hold the tool at a right angle to the work surface.
Always turn the tool off before storing. As an added protection feature, the tool will
Indicator LED
ON-Flashing
automatically turn off 34 minutes after the last activation.
If a nail jam occurs, the red light at the mode selector switch will flash red. The tool
will attempt to recover.
If the jam is severe, the driver blade will lock in place by design and the red flashing
light will not clear. Contact an authorized service center.
Should a minor fastener jam occur:
Turn the tool off by depressing the selector switch towards either mode symbol for
approximate ly 1 second, then remove battery.
Insert battery and turn tool back on via mode selector switch. Tool will attempt to
recover.
Should a severe fastener jam occur:
Turn the tool off by depressing the selector switch towards either mode symbol for
approximate ly 1 second, then remove battery.
Remove fasteners from magazine.
Wear safety glasses when removing magazine.
Remove jammed fastener with a pliers or screwdriver.
Do not tamper with the drive assembly.
Re-attach the magazine or close the magazine.
Insert battery and turn tool back on via mode selector switch. Tool will attempt to
recover.
If tool indicates a jam again via red light, return tool to authorized service center for
evaluation
TOOL OPERATION
Point nose of tool away from self and others.
Follow the unloading instructions to remove fasteners from magazine.
Remove the magazine (F-15XP) or keep the magazine open (F-16XP
and F-18XP).
Remember! The Fusion tool is charged with compressed air in a
factory sealed chamber.
Do not push on the driver with any force or use a hammer to strike the
driver while it is visible.
17