Table of Contents
Advertisement
UNLOADING THE TOOL, F-15XP:
Push Button on feeder shoe to release feeder from strip. Pull fastener strip out past sheet metal nail detainer.
Tool Operation
Read section titled "Safety Warnings," before using tool.
For best results, charge new battery before using. (see "To Charge Battery" on page 17).
Indicator LED ON
All Fusion tools are equipped with selective-actuation triggering. This allows the user to choose between the
following modes of operation:
Indicator LED
ON-Flashing
TOOL OPERATION
LOADING THE TOOL, F-15XP:
Insert strip of nails into rear of magazine.
• Use only genuine SENCO fasteners (see Fastener Specifications).
• Do not load with workpiece contact (safety element) or trigger
depressed.
Pull feeder shoe back.
LOADING THE TOOL, F-16XP AND F-18XP:
Open magazine via rear latch.
Place genuine fastener in magazine with nail tip against bottom of rail.
Push magazine forward until "click" is heard.
To unload, open magazine via rear latch.
The tool should be switched off when not in use. Hold down either side of the selector
switch for 1 second to turn the tool off. If left on, the tool will automatically turn off
after 34 minutes.
Contact Actuation
Pressing the side of the selector switch toward the T T T symbol (as shown) for 0.5
sec. will turn the tool on in contact-actuation mode. This is indicated by the flashing
green LED of the selector switch.
13
Advertisement
Table of Contents
