Senco Fusion F-15XP Operating Instructions Manual page 16

This tool is equipped with an electronic "Time-Out" feature. This tool will temporarily
12
be disabled under any of the following conditions:
9 3
6
2
1
The tool is equipped with a last fastener lockout. The tool will not fire the last 5
fasteners in the F-15XP angled tool. The F-16XP and F-18XP tools are designed to
stop firing after the last fastener is driven. This feature prevents unnecessary wear on
the tool and prevents the driver tip from marring the workpiece. When the tool locks
out, load an additional strip and continue. It is not necessary to remove the remaining
fasteners from the magazine.
This tool is equiped with a dual-purpose light on the nosepiece. The light will indicate
that the electronic controls are energized while providing illumination of the workpiece
in low light situations. The light will flash three times when the selector switch is
switched to either sequential or contact actuation. This lets the user know that the tool
is ready to fire a fastener. The light will remain on for ten seconds when the trigger is
pulled or the work contact element is depressed.
This tool is equipped with depth-of-drive dial. Turning the dial to the right will counter-
sink the fastener, turning the dial to the left will leave the fastener up or raised. Drive a
fastener into a scrap piece of wood to test depth.
Turning the dial in the direction shown in the image will result in the fastener driving
deeper into the wood.
TOOL OPERATION
1. Workpiece contact element is depressed against the work piece, but the trigger
is not pressed within approximately 10 seconds.
2. Trigger is pressed, but work piece contact element is not depressed within
approximately 3 seconds. (Contact-Actuation mode only.)
• Simply release trigger and release workpiece contact element to resume
normal operation.
This tool is equipped with an adjustable 6 position belt hook for
right and left handed operators. The hook will safely support the
tool when hanging from joists and rafters.
Rotate the knurled knob to adjust opening or to switch from
right to left side. Move black plastic cap to alternate side to
complete assembly.
16