Preparation
Assembly of Components
Assembly of Components
Installing the Expiratory Valve
WARNING !
Always install expiratory valve that has been
cleaned and disinfected.
NOTE: Refer to page 112 for re-assembly of a
disassembled expiratory valve.
Push patient block fully into mounting receptacle.
Check that it is properly engaged by gently pulling on
the port. It should stay securely attached.
Mounting a Flow Sensor
1 Push connector socket all the way to the left
2 Gently push flow sensor into its mount – with the
connector facing towards the ventilator – and into the
socket as far as it will go.
Then:
3 Push flow sensor to the right and into the rubber lip
seal of the expiratory valve as far as it will go.
34
1
2
3