Advertisement
CIP Training L5160/L5130
Setting Media
43.
Fix the central tip of the media to the empty roll core with adhesive tape. When using soft
media, fix the right edge, center, and left edge with adhesive tape.
•
When fixing the left edge, center, and right edge with adhesive tape, after fixing the
center, pull the left and right sides of the media equally, and then fix the left and right
edges so that sagging or wrinkles cannot occur.
•
Fix the media with it taut. If the media is hanging down, it may cause rolling defects.
When placing the printing surface on the outside and rolling up media
Roll the media from the front of the roll core to the inside to fix it.
2
When placing the printing surface on the inside and rolling up media
Roll the media from the back of the roll core to the front to fix it.
2
44. Press [Feed] to slacken the media, and then rotate the roll core manually to roll the media
around the roll core a few times.
Ensure there are no folds in the edges of the media.
DWT144
1
2
DWT145
1
2
DWT146
Advertisement
