Advertisement
CIP Training L5160/L5130
Setting Media
• If the media is difficult to insert because the edges of the media are getting caught,
diagonally insert the media between the rollers, so that one corner gets inserted first. Ensure
the media is inserted evenly, and begin feeding.
• Holding the edge of the media, adjust the angle at the leading edge of the media and load it.
• If there is no media on the sensor, the machine cannot detect media successfully. Set media so
that it covers the media sensor on the left side of the feeding surface.
• Withdraw the media approximately one hand grip's worth from the media feeding surface on
the front of the machine.
• If the edge of the media is out of the range of the pre-heater's scale, release the roll holder's
holding lever, and then adjust the roll holder's position.
• Align the edge of the media, and then load the media while adjusting media position by hand
so that it is stretched evenly. It helps to load the media evenly by holding the flange or edge
of the media and controlling the roll media's rotation. When you do this, check scale
indicating the edge of the media.
DWT162
DWT163
Advertisement
