Advertisement
CIP Training L5160/L5130
Setting Media
45. Set the roll-up switch to the on position.
When placing the printing surface on the outside and rolling up media
Lower the roll-up switch (normal rotation).
When placing the printing surface on the inside and rolling up media
Raise the roll-up switch (reverse rotation).
46. Press [Completed].
Wait until "Ready" is displayed on the home screen.
• If an unsupported media is set, "Cannot detect the media." appears. Set
supported media again. For details about supported media, see "Supported
Media".
• If there is media floating on the media sensor, the media may not be detected
correctly.
• Depending on the operating environment and media, the machine may not be
able to correctly detect the media width. If the media width is not detected
correctly, perform the following tasks:
• Set the media again.
• Check whether outside light is reflecting on the media surface.
• Perform "Cleaning the Media Sensors", Requests for Daily Care and
Maintenance.
• To prevent media skewing during feeding, wait until the heaters reach the set
temperature before setting the media.
DWT147
DWT148
Advertisement
