Advertisement
CIP Training L5160/L5130
Setting Media
• When you load the media, if the arm near the media cutter is positioned
behind the media, you cannot cut the media correctly.
Correct
If you touch the cutter part, the arm near the cutter may close. If this happens, move the media
to a position unreachable by the cutter, and then execute [Origin Setting / Cut] to cut.
42.
When using thick or hard media, hold the tip of the media at the center and cut the left and
right sides at equal angles.
•
When cutting both edges of the media, the media can be rolled up equally by
preventing the left and right sides from bending and being caught.
•
When using soft media, do not cut the media.
Incorrect
1
DWT074
1
1.
Arm
DWT076
DWT143
1
DWT075
Advertisement
