Advertisement
CIP Training L5160/L5130
Setting Media
30. Press [Remaining Media].
When [Display Remaining Media] is set to [On] in [Media Display Settings] on
the [Initial Setting] screen, the input screen for the remaining amount of media
is displayed after detecting the media width. For details, see "Registering the
Remaining Amount of Media".
31. Enter the length of the set media using the number keys, and then press [Set].
32. When changing the media type, press [Media Type].
33. Select the media type of the set media, and then press [Set].
34. When changing the thickness of the media, press [Media Thickness].
35. Select the thickness of the set media, and then press [Set].
36. When changing the height of the print heads, press [Head Height].
37. Select the height of the print heads from [Default], [+1], [+2], or [+3] depending
on the thickness of the media, and then press [Set].
Set the height of the print heads so that it does not interfere with the media.
However, having too much space between the media and the print heads can
also have a negative impact on print quality.
38. When changing the media width, press [Media Width] after pressing [ ].
39. Select the width of the set media, and then press [Set].
40. Press [Next].
The media feed screen appears.
41. Hold down [Feed] until the media is fed to the roll core holder.
• If the media is fed over the roll core holder, press [Rewind] and adjust the
position of the media.
• When the vacuuming of media is insufficient, press [Vac.Lv. Change], and
then change the vacuum level. The vacuum level can be set in 9 steps.
Advertisement
