Advertisement
CIP Training L5160/L5130
Setting Media
14. While holding down the center of the media, lower the media holding lever (back).
The pinch rollers lower and the media is fixed.
15. Return the pre-heater cover to its original position.
• After returning the pre-heater cover to its original position, press its ends to
make sure that it is not bulging.
• If you operate the device with a bulge in the pre-heater cover, the cover may
come open during operation or printing.
16. Open the center cover on the front of the machine.
17. While holding down the center of the media, raise the media holding lever (front).
The pinch rollers rise and the media is unfixed.
18. Holding it at the center, pull the media evenly out of the paper exit.
Align the edge of the media to the post-heater's scale so that it matches the value on
the pre-heater's scale.
DWT133
DWT134
DWT135
Advertisement
