Table of Contents
Advertisement
OUTDOOR SERIES
installation
|
26
7. Re-install pilot cap.
8. Adjust air shutter to 1/4 inch open by loosening the screw on the air shutter.
Retighten screw after adjustment.
9. Remove 8 screws on valve access cover.
10. Remove Hi/Lo pressure regulator by removing 2 screws as shown below.
Reverse steps to install LP pressure regulator. (Be sure diaphragm
and spring are removed from the original regulator.)
11. Attach the label "This unit has been converted to LP" near or on top
of the serial # decal.
12. Replace yellow "NG" label with red "LP" label.
Make appropriate gas connections.
13. Reverse Steps 1-6
14. C heck all gas connections under normal operating pressure, for leaks,
with soapy water.
NOTE: If soap bubbles, this would indicate a gas leak.
15. Check inlet and outlet pressures.
16. Check operation of flame control.
26 |
Regency Horizon
®
HZO60 Gas Fireplace
HI/LO Pressure
Regulator
Advertisement
Table of Contents
