Checking Wheel Bolt Torque; Every 100 Hours; Checking Battery Condition - Kubota B1620 Operator's Manual

54 PERIODIC SERVICE
(1) Clutch pedal
(2) Main gear shift lever
(3) PTO gear shift lever
(4) Parking brake
(5) Seat
BChecking Wheel Bolt Torque
To avoid personal injury:
A Never operate tractor with a loose rim, wheel,
or axle.
A Any time bolts and nuts are loosened, retighten
to specified torque.
A Check all bolts and nuts frequently and keep
them tight.
Check wheel bolts and nuts regularly especially when
new. If they are loose, tighten them as follows.
(1) Nut: 77 to 90 N-m (7.9 to 9.2 kgf-m)
(1) 123 to 147 N-m (12.6 to 15.0 kgf-m)
(2) 108 to 125 N-m (11.0 to 12.8 kgf-m)

EVERY 100 HOURS

BChecking Battery Condition
To avoid the possibility of battery explosion:
For the refillable
instructions below.
A Do not use or charge the refillable type battery
if the fluid level is below the LOWER (lower limit
level) mark. Otherwise, the battery component
parts may prematurely deteriorate, which may
shorten the battery's service life or cause an
explosion. Check the fluid level regularly and
add distilled water as required so that the fluid
level is between the UPPER and LOWER levels.
To avoid personal injury:
A Never remove the battery cap while the engine
is running.
A Keep electrolyte away from eyes, hands and
clothes. If you are spattered with it, wash it
away completely with water immediately and
get medical attention.
A Keep open sparks and flames away from the
battery at all times. Hydrogen gas mixed with
oxygen becomes very explosive.
A Wear eye protection and rubber gloves when
working around battery.
The factory-installed battery is of non-refillable
type. If the indicator turns white, do not charge the
battery but replace it with new one.
type battery, follow the