Installation Instructions; Required Tools; Shipping Crate; Package Contents - IDEAL 7000TLX Assembly & Operation Manual

Automotive tilt lift 7,000 lb. capacity

Hide thumbs

Table Of Contents

Table of Contents

These instructions must be followed to ensure proper installation and operation of your lift.

Failure to comply with these instructions can result in serious bodily harm and void product

warranty. Manufacturer will assume no liability for loss or damage of any kind, expressed or

implied resulting from improper installation or use of this product.

Required Tools

Scissors

Hammer or Small Crowbar

30mm Open-End Wrench

30mm Socket Wrench

10 Amp* 120VAC 1/2" Corded Drill - DO NOT Use Impact Drill !!

(*Less than 10 Amps may cause difficulty raising larger & heavier vehicles)

Shipping Crate weight is approximately 215 lbs. Careful attention should be taken for offloading

& maneuvering Crate. The 66.3"L x 34.8"W x 10.4"H Crate is designed for easy mobility with

forklift or pallet jack.

Shipping Crate

1. Inspect shipping crate for any damages.

2. Open shipping crate by first cutting banding,

followed by carefully prying lid open.

3. Carefully remove all contents from crate, using

Package Contents list & diagram below to ensure

all items are included.

Package Contents

A. Tilt Lift Frame Assembly (1)

B. Platform (2)

C. Platform Hardware:

· Pivot Bar (2)

· Spacer (4)

· Flat Washer (4)

· Nylon Nut (4)

D. Platform Riser Bar (2)

E. Drill Drive Adapter (4)

F. Safety Lock Pin (2)

G. Handle & Socket Adapter (1)

H. Wall Storage Bracket (2)

I. Jack Stand

For Convenience

The iDEAL 7000TLX Tilt Lift comes

almost fully assembled.

Only the Platform Assemblies need

to be mounted to the Tilt Lift Frame.

(See Assembly Info Next)