Operation - Makita DWT310 Instruction Manual

► 1 . Outer sleeve 2. Screw
NOTICE:
Make sure that there is no gap between
the outer sleeve and the tool.

OPERATION

CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see the
red indicator on the upper side of the button, it is not
locked completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around you.
CAUTION:
Keep the bolt tips off of the
ground, floor, walkways, etc. to prevent injury
from tripping or falling.
1. Tighten bolts preliminarily by using a hand wrench.
2. Hold the tool firmly and place the inner sleeve over the
bolt so that the inner sleeve completely covers the bolt tip.
► 1 . Inner sleeve 2. Bolt tip
NOTICE:
the bolt tip. Striking the tip can damage it so that it
will no longer fit inside the sleeve properly.
3. Push the tool lightly until the outer sleeve completely hold
1
the nut. If the outer sleeve fails to hold the nut, rotate the tool
2
clockwise or counterclockwise while pushing the tool lightly.
4.
Press the trigger-lock button, and then pull the
switch trigger. The outer sleeve rotates to tighten the nut.
► 1 . Outer sleeve 2. Nut
NOTICE:
the downward force to the degree needed to stabilize the tool.
5. When the specified torque is attained, the bolt
tip will be sheared at its notched portion. The bolt tip
remains inside the inner sleeve.
► 1 . Notched portion 2. Bolt tip
6.
Release the switch trigger and withdraw the tool in
a straight line.
1
2
► 1 . Outer sleeve
8 ENGLISH
Be careful when fitting the sleeve onto
1
2
Do not force the tool down excessively. Apply
1
2
1