Makita DWT310 Instruction Manual page 6

Overheat protection
When the tool or battery is overheated, the tool stops
automatically. In this case, let the tool and battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the
tool and charge the battery.
Switch action
WARNING:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided.
To start the tool, depress the trigger-lock button from A side
and pull the switch trigger. Release the switch trigger to
stop. After use, press in the trigger-lock button from B side.
A
► 1 . Trigger-lock button 2. Switch trigger
NOTE: The tool automatically stops if you keep pull-
ing the switch trigger for about 6 minutes.
When you pull the eject lever, the bolt tip is ejected from
the tool.
► 1 . Eject lever
1
2
1
Battery power lamp
When the remaining battery capacity becomes low, the battery
power lamp blinks. Charge the battery or replace the battery with
fully charged one. When the remaining battery capacity becomes
much lower, the tool stops and the battery power lamp lights up.
► 1 . Battery power lamp
Hook
CAUTION:
included in the tool as the standard accessory. Use the
shoulder belt for carrying the tool, and never use the
hook for other purposes such as the fall prevention
at high location. If the hook is used for other purposes,
excessive load may break them and cause serious injury to
the operator and person around/underneath the operator.
CAUTION:
the hook, be sure to attach it securely. If it is attached
incompletely, the tool may come off and cause an injury.
CAUTION:
shoulder belt, be careful not to entangle the shoulder
B
belt with your body or objects and not to hit objects
with the tool. Failure to do so may cause an accident.
CAUTION:
hook before operating the tool. Failure to do so may
lose your balance at operation and cause an accident.
► 1 . Hook 2. Shoulder belt
Attach the shoulder belt included in the tool as the stan-
dard accessory to the hook for carrying the tool. Remove
the shoulder belt from the hook before operating the tool.
6 ENGLISH
Be sure to attach the shoulder belt
When you attach the shoulder belt to
When carrying the tool using the
Remove the shoulder belt from the
1
1
2