Makita DWT310 Instruction Manual page 7

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing the outer and inner
sleeves
CAUTION:
Be careful not to allow foreign mat-
ter to enter the insides of the tool when removing
or installing the outer and inner sleeves.
1. Loosen the two screws while holding the outer
sleeve. The outer and inner sleeves will be pushed up
by the springs built into the tool.
► 1 . Outer sleeve 2. Screw
2. Press the pin down to remove the inner sleeve
from the outer sleeve.
► 1 . Inner sleeve 2. Pin 3. Outer sleeve
NOTICE:
Be careful not to drop the inner sleeve
when removing it.
NOTICE:
Do not remove the tip rod, tip rod
spring, and inner sleeve spring from the tool.
► 1 . Tip rod 2. Tip rod spring 3. Inner sleeve spring
Installing the outer and inner
sleeves
1
Place the inner sleeve with the pin facing upward.
Attach the outer sleeve to the inner sleeve securely
2
while pressing the pin of the inner sleeve.
► 1 . Outer sleeve 2. Pin 3. Inner sleeve
1
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve clockwise and counterclock-
2 wise until the outer sleeve touches the tool. Tighten the
two screws firmly.
3
7 ENGLISH
1
2
3
1
2
3