Procedure
1. Open the release handles (rotate the top handle up and the bottom handle
2. Slide the media tray out of the BladeCenter S chassis.
3. If you are instructed to return the media tray or DVD drive, follow all
What to do next
Installing the media tray
You can install the media tray while the BladeCenter S system is powered on. To
install it, slide it into the BladeCenter S chassis and close the release handles.
About this task
Important: If you are installing the media tray in a BladeCenter S chassis in which
SAS RAID controller modules are installed, refer to the IBM BladeCenter SAS RAID
Controller Installation and User's Guide for additional steps that might need to be
performed.
84
BladeCenter S Type 7779/8886: Problem Determination and Service Guide
Media tray
down) to disengage the media tray from the BladeCenter S chassis.
Note: When you remove the media tray, the fan modules will begin to run at
full speed.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Media tray