Table of Contents
Advertisement
8
e.
For cabinet with recessed-bottom, use (2) 3" x 12" or 15" wood strips on
both sides to balance the recession. Use (4) 1-1/4" long flat head screws
to secure the wood strips to cabinet. (Fig. 1d)
3.
HOOD
a.
Inspect for any sign of defect or damage. (ie. scratches, dents, loose
seams, etc.)
b.
Power up the unit to make sure it is working properly.
c.
Remove the protective film on the baffle filters and fillers.
PREPARATION
INSTALLATION
INSTALLATION
1. UNDER CABINET INSTALLATION
a.
Make sure all preparation steps are completed.
b.
Feed the wires coming out of the hood through the bottom of the cabinet.
c.
Lift the unit up flush against the wall and bottom of the cabinet.
d.
Using the screws and washers provided, insert into each of the keyhole
openings and tightly secure the unit against the bottom of the cabinet.
NOTE: Install more screws through the back of the unit if necessary.
e.
Use the conversion collar for 7" ducting.
f.
Connect 6" or 7" ducting to the collar of the hood.
g.
Finish off by sealing the connection point with aluminum tape.
2. COLD WEATHER INSTALLATION (OPTIONAL)
a.
Check with your local building codes to see if a 6" CFM reducer is an
acceptable alternative to make-up air.
b.
Remove the RA-30CFMR (CFM Reducer) and inspect for any sign of
defect or damage. (ie. Cracks, broken flips)
c.
For UNDER CABINET installation: COMPLETE Step A – D of Section
1 UNDER CABINET INSTALLATION THEN GO TO STEP E BELOW.
d.
Place the CFM reducer onto the outlet of the unit and seal the connection
point with aluminum tape. (Be sure it is secure with no openings or gaps)
e.
Connect a 6" ducting to the collar of the CFM reducer.
f.
Finish off by sealing the connection point with aluminum tape.
9
Advertisement
Table of Contents
