Adjusting The Camera - Viking E-75-SS Technical Practice

F. Wiring the E-75 Camera
1. Using RG59 for Video and CAT5 for Camera Power and Phone Board Audio (Recommended)
VIKING
2. Using CAT5E or CAT6 for Video, Camera Power and Phone Board Audio (see Caution below)
VIKING
* Note: Up to 150 ft video cable run length can be achieved using CAT5E or CAT6 cable. Longer cable runs can be used if a passive or active video
Balun transceiver is used on each end of the cable. Generally, passive transceivers can achieve up to 750 ft cable runs where active transceivers
can achieve up to 3000 ft runs depending on cable type, etc. The type of video balun transceiver required is specific to your cable run length. For
more information on video balun transceivers go to: www.northernvideo.com.
** Note: The maximum camera power supply wire run length is 1000 ft of 24 gauge wire (CAT 5/6), longer runs are possible by doubling pairs,
increasing the wire gauge or using up to a 22V DC 200mA power adapter.
*** Note: RG59 or RG6 with solid center conductor and 95% bare copper braid shield.
Caution: When routing CAT5E or CAT6 cable, maintain a minimum distance of 3 ft from any parallel high voltage wire (110 VAC) and a minimum of
2 ft from crossing any high voltage wire. For installations where RF noise is expected (commercial applications) or wire runs are near high voltage
(110 VAC) wires, a shielded video cable such as RG6 is recommended.
G. Adjusting the Camera
The camera can be tilted and rotated to your desired
position. A portable service (test) monitor can be used to
determine the correct viewing angle during installation.
Important: To prevent the edge of the faceplate from
being viewed in the video image, do not rotate the cam-
era beyond 30 degrees or tilt beyond 20 degrees.
Back View of the E-75 Circuit
Board Mounting Plate
3-Wire Gel-Filled Butt Connectors
included (3M Scotchlok UR2)
Center conductor
stripped back 5/8"
Yellow
Twisted foil and braided shield
(Video)
Yellow/Red
Black
- Black (GND)
**** Female "F" to Wire or "BNC" to Wire
Converter Cable (not included)
** Camera GND (-)
+ Red (12VDC)
** Camera Pwr (+)
Phone Board
Green (Tip)
Audio In/Out
W/BL
Phone Board
Red (Ring)
Audio In/Out
Blue
Back View of the E-75 Circuit
Board Mounting Plate
3-Wire Gel-Filled Butt
Connectors included
(3M Scotchlok UR2)
Yellow (Video)
Video Out (+)
W/G
Video GND (-)
Green
- Black (GND)
** Camera GND (-)
+ Red (12VDC) ** Camera Pwr (+)
Phone Board
Green (Tip)
Audio Out
W/BL
Phone Board
Red (Ring)
Audio Out
Blue
IMPORTANT: Electronic devices are susceptible to lightning and power station elec-
!
trical surges from both the AC outlet and the telephone line. It is recommended that
a surge protector be installed to protect against such surges.
*** RG59 or RG6 Shielded
Connector
Video Cable, up to 1000 ft
OR **** For ease of installation, a Viking Female
"F" to Wire Converter Cable can be used (Part
# 261217) or "BNC" to wire converter cable
(Part # U213510) can be used. Go to
www.vikingelectronics.com
"Spare Parts" to order.
CAT5 Cable
W/O
Orange
** Up to 1000 ft
CAT5E or
CAT6 Cable
(see Caution below)
W/O
Orange
* Up to 150 ft
Vertical (Tilt)
Adjustment
+/- 20 degrees
maximum
Horizontal (Rotation)
Adjustment
+/- 30 degrees maximum
"F"
"F" to Phono Plug
Adapter
(Radio
To unused input on TV,
Shack part #278-252)
VHF modulator, whole
house video distribution
equipment, IP video
encoder (Axis M7001), etc.
12V DC Adapter
and click on
(included)
(-)
Camera GND (-)
W/O
Orange
Camera Power (+)
Crimp-on Splice
Connectors (not included)
Blue W/BL
See page 4, section E
Wiring Phone Board
To unused input on TV, VHF
modulator, whole house video
distribution equipment, IP video
encoder (Axis M7001), etc.
Video Out (+)
Video GND (-)
Phono (RCA) Plug,
F Connector, Etc.
W/G Green
12V DC Adapter
(included)
(-)
Camera GND (-)
W/O
Orange
Camera Power (+)
(4) Crimp-on Splice
Connectors (not included)
Blue W/BL
See page 4, section E
Wiring Phone Board
VIKING
!
120V AC
( + )
(-)
(+)
!
120V AC
( + )
5