Adjusting The Camera; Dip Switch Programming - Viking K-1705-3 Technical Practice

2. Using CAT5E or CAT6 for Video, Camera Power and Phone Board Audio (see Caution below)
Back View of the K-1705-3
RoHS
Reg. No.: AH3USA-32531-TE-E
REN: 1.0B P/N: 260836-1 DEV:
J1 J1 J1
Viking Electronics, Inc. (715)386-8861
1531 Industrial St., Hudson, WI 54016
on on
1 2 3 4 1 2 3
J2
J3
8 1
J3
A
* Note: Up to 150 ft video cable run length can be achieved using CAT5E or CAT6 cable. Longer cable runs can be used if a passive or active video Balun transceiver is used on
each end of the cable. Generally, passive transceivers can achieve up to 750 ft cable runs where active transceivers can achieve up to 3000 ft runs depending on cable type, etc.
The type of video balun transceiver required is specific to your cable run length. For more information on video balun transceivers go to: www.northernvideo.com.
** Note: The maximum camera power supply wire run length is 500 ft of 24 gauge wire (CAT 5/6), longer runs are possible by doubling pairs or increasing the wire gauge.
RG59 or RG6 with solid center conductor and 95% bare copper braid shield.
Caution: When routing CAT5E or CAT6 cable, maintain a minimum distance of 3 ft from any parallel high voltage wire (110 VAC) and a minimum of 2 ft from crossing any high volt-
age wire. For installations where RF noise is expected (commercial applications) or wire runs are near high voltage (110 VAC) wires, a shielded video cable such as RG6 is recom-
mended.
G. Adjusting the Camera
The camera can be tilted and rotated to your desired
position. A portable service (test) monitor can be used to
determine the correct viewing angle during installation.
To prevent the edge of the faceplate from
being viewed in the video image, do not rotate the cam-
era beyond 30 degrees or tilt beyond 20 degrees.
A. Dip Switch Programming
Switch 1 Switch 2
OFF OFF
ON OFF
OFF
ON
ON
ON
Switch 3 Switch 4
OFF OFF
ON OFF
OFF
ON
ON
ON
Switch 5 Auto Answer Feature
OFF Automatic answer disabled
ON Automatic answer enabled (default)
Switch 6 Push Button Feature
OFF Connects calls only
ON Connects/disconnects calls (default)
3-Wire Gel-Filled Butt
Connectors included
(3M Scotchlok UR2)
Video Out (+)
Yellow (Video)
Video GND (-)
- Black (GND)
** Camera GND (-)
** Camera Pwr (+)
+ Red (6VDC)
Phone Board Audio In/Out (Tip)
Phone Board Audio In/Out (Ring)
Maximum Call Time
Disabled (default)
1 minute
3 minutes
9 minutes
Disconnect on Silence
Off
10 seconds
40 seconds (default)
90 seconds
CAT5E or
W/G
CAT6 Cable
(see Caution below)
G/W
W/O
O/W
* Up to 150 ft
W/BL
BL/W
Horizontal (Rotation)
Adjustment
+/- 30 degrees maximum
Vertical (Tilt)
Adjustment
+/- 20 degrees
maximum
Rear View of
the K-1705-3
Switch 7 VOX Switching Speed
OFF Fast, 0.2 seconds (default)
ON Slow, 0.7 seconds
To unused input on TV, VHF
modulator, whole house video
distribution equipment, etc.
Video Out (+)
Video GND (-)
Phono (RCA) Plug,
F Connector, Etc.
W/G G/W
6V DC Adapter
(included)
Black
(-)
Camera GND (-)
W/O
Camera Power (+)
O/W
(4) Crimp-on Splice
Connectors (not included)
BL/W W/BL
See page 4, section E
Wiring Phone Board
1 2 3
ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PRS TUV WXY
0 #
OPER
VIKING
©
Reg. No.: AH3USA-32531-TE-E
1.0B
REN: P/N: 260836-1 DEV:
J1 J1
J1
Viking Electronics, Inc. (715)386-8861
1531 Industrial St., Hudson, WI 54016
on
1 2
J2
J3
8
J3
A
ON ON
ON ON
1 2 3 4 1
OFF OFF
1 2 3 4 5 6 7
DIP Switches
(shown in default positions)
(-)
(+)
!
120V AC
( + )
Black with
White Stripe
Call
RoHS
on
3 4 1 2 3
1
2 3
5