Table of Contents
Advertisement
F. Wiring the E-50 Camera
1. Using RG59 for Video and CAT5 for Camera Power and Phone Board Audio (Recommended)
VIKING
2. Using CAT5E or CAT6 for Video, Camera Power and Phone Board Audio (see Caution below)
VIKING
* Note: Up to 150 ft video cable run length can be achieved using CAT5E or CAT6 cable. Longer cable runs can be used if a passive or active video
Balun transceiver is used on each end of the cable. Generally, passive transceivers can achieve up to 750 ft cable runs where active transceivers
can achieve up to 3000 ft runs depending on cable type, etc. The type of video balun transceiver required is specific to your cable run length. For
more information on video balun transceivers go to: www.northernvideo.com.
** Note: The maximum camera power supply wire run length is 500 ft of 24 gauge wire (CAT 5/6), longer runs are possible by doubling pairs or
increasing the wire gauge.
*** Note: RG59 or RG6 with solid center conductor and 95% bare copper braid shield.
Caution: When routing CAT5E or CAT6 cable, maintain a minimum distance of 3 ft from any parallel high voltage wire (110 VAC) and a minimum of
2 ft from crossing any high voltage wire. For installations where RF noise is expected (commercial applications) or wire runs are near high voltage
(110 VAC) wires, a shielded video cable such as RG6 is recommended.
G. Adjusting the Camera
The camera can be tilted and rotated to your desired
position. A portable service (test) monitor can be used to
determine the correct viewing angle during installation.
Important: To prevent the edge of the faceplate from
being viewed in the video image, do not rotate the cam-
era beyond 30 degrees or tilt beyond 20 degrees.
Back View of the E-50 Circuit
Board Mounting Plate
3-Wire Gel-Filled Butt Connectors
included (3M Scotchlok UR2)
Center conductor
stripped back 5/8"
Yellow (Video)
Twisted foil and
braided shield
- Black (GND)
** Camera GND (-)
+ Red (6VDC)
** Camera Pwr (+)
Phone Board
Green (Tip)
Audio In/Out
Phone Board
Red (Ring)
Audio In/Out
Back View of the E-50 Circuit
Board Mounting Plate
3-Wire Gel-Filled Butt
Connectors included
(3M Scotchlok UR2)
Video Out (+)
Yellow (Video)
Video GND (-)
- Black (GND)
** Camera GND (-)
** Camera Pwr (+)
+ Red (6VDC)
Phone Board
Audio Out
Green (Tip)
Phone Board
Audio Out
Red (Ring)
IMPORTANT: Electronic devices are susceptible to lightning and power station
!
electrical surges from both the AC outlet and the telephone line. It is recommend-
ed that a surge protector be installed to protect against such surges. Contact
Panamax at (800) 472-5555 or Electronic Specialists Inc. at (800) 225-4876.
*** RG59 or RG6
Shielded
Video Cable
Up to 1000 ft
CAT5 Cable
W/O
O/W
** Up to 500 ft
W/BL
BL/W
CAT5E or
W/G
CAT6 Cable
(see Caution below)
G/W
W/O
O/W
* Up to 150 ft
W/BL
BL/W
Vertical (Tilt)
Adjustment
+/- 20 degrees
maximum
"F" to Phono Plug
"F"
Adapter
(Radio
Connector
Shack part #278-252)
6V DC Adapter
(included)
Camera GND (-)
W/O
O/W
Camera Power (+)
Crimp-on Splice
Connectors (not included)
BL/W
W/BL
See page 4, section E
Wiring Phone Board
To unused input on TV, VHF
modulator, whole house video
distribution equipment, etc.
Video Out (+)
Video GND (-)
W/G
G/W
6V DC Adapter
(included)
Camera GND (-)
W/O
Camera Power (+)
O/W
(4) Crimp-on Splice
Connectors (not included)
BL/W
W/BL
See page 4, section E
Wiring Phone Board
Horizontal (Rotation)
Adjustment
+/- 30 degrees maximum
To unused input on TV,
VHF modulator, whole
house video distribution
equipment, etc.
!
Black
120V AC
(-)
( + )
Black with
White Stripe
(-)
(+)
Phono (RCA) Plug,
F Connector, Etc.
!
Black
120V AC
(-)
( + )
Black with
White Stripe
5
Advertisement
Table of Contents
