Advertisement
WHEN USING THE TOOL FOR STEEL PLATES
● Carry out work based on the required Work Standards.
● If there is no specified work standard, refer the following as a reference.
● Never use the nails for the ceilings (ceiling foundations included) or
● Be sure to apply discharge outlet to an object at a right angle.
● Do not drive the nails into the steel plate directly.
This tool is exclusively designed for 1.6 mm (1/16") to 3.2 mm (1/8") thick light gage steel.
When using it, comply with the Work Standards, considering the object condition and work site
environment.
Select appropriate nails according to the
object thickness, seeing the right table.
* The nails may not be driven into the object
depending on its hardness or thickness.
* If the object is thinner than an appropriate
range of thickness, the nails may not be
driven into it because of being bent.
Wood
Object thickness
(Total )range
Penetration
amount
Light gage steel:
1.6 mm (1/16") to
3.2 mm (1/8") thick
* For the 3.2 mm (1/8") thick light
φ
gage steel, use the
2.9 mm (.113")
nails.
!
WARNING:
roofs (roof foundations included).
If the thickness of the light gage steel foundations material used is
3.2 mm (1/8"), use the φ 2.9 mm (113") nails.
Never drive the nails directly into the light gage steel because they
will fly off, endangering you.
Be sure to apply the discharge outlet to the object at a right angle.
If applied obliquely, the nails will fly off, endangering you.
Never use the nails for the roofs (roof foundations included) or
ceilings (ceiling foundations included).
If the nails are driven into the steel plate too deeply, their holding
force will be extremely reduced. When working with the tool, fully
check the driven conditions.
Nail Selection Criteria
Diamete
Length
2.5mm
45mm
(.099")
(1-3/4")
2.5mm
50mm
(.099")
(2")
2.5mm
57mm
(.099")
(2-1/4")
2.5mm
60mm
(.099")
(2-3/8")
14
Object
Light gage steel
thickness
thickness
(Total) range
25 to 35mm
1.6 to 2.3mm
(1" to 1-3/8")
(16 Gage to 13 Gage)
25 to 40mm
1.6 to 2.3mm
(1" to 1-1/2")
(16 Gage to 13 Gage)
35 to 45mm
1.6 to 2.3mm
(1-3/8" to 1-3/4")
(16 Gage to 13 Gage)
40 to 55mm
1.6 to 2.3mm
(1-1/2" to 1-1/8")
(16 Gage to 13 Gage)
Advertisement
