NTI Triton VS80 Assembly, Installation And Operation Instructions page 2

Oil boiler
Table of Contents

Advertisement

Triton
Installation and Operation Instructions
Read Before Proceeding
If you do not follow these instructions exactly, a fire may result causing property
damage, serious injury or death.
BEFORE OPERATING:
A. Do not start burner unless the smoke hood, clean out door, HydroStat 3250, flue breeching, and burner
door (if applicable) are secured in place and the boiler is filled with water.
B. Do not attempt to starter burner when excess oil has accumulated in combustion chamber, when unit is
full of vapour, or when combustion chamber is very hot.
C. Do not use gasoline, crankcase drainings, or any oil containing gasoline.
D. Never burn garbage or paper in the unit and never leave combustible material around it.
E. Always keep the oil supply valve shut off if the burner is shut down for an extended period of time.
F. Do not tamper with the unit or controls - call your service personnel for service and maintenance.
G. Do not use this boiler if any part has been under water. Immediately call a qualified service technician to
boiler and to replace any part of the
inspect the
under water.
1. STOP! Read the safety information above very carefully.
2. Initial start-up and start-ups after periods of extended/seasonal shutdown must be performed by a
qualified service technician.
3. Check the boiler area for proper clearances.
4. Turn the thermostat(s) up.
5. Turn the emergency power isolation switch on.
6. If ignition does not occur, follow the instructions "To Turn Off Oil Boiler" and call a qualified service
technician.
1. STOP! Read the safety information above very carefully.
2. Turn off emergency power isolation switch. Should be mounted on the wall near entrance to boiler room.
Void Warranty - This Boiler must have water in the boiler whenever the burner is on or
it will damage the unit and void the warranty. Failure to follow these instructions may
result in serious injury or death.
Fuel Oil - Use only No. 2 fuel oil for boiler models listed in this manual. Failure to follow
these instructions may result in severe personal injury, property damage, or death.
Low Water Cut Off (LWCO) - The HydroStat 3250, when installed in a Caprice or
Triton boiler, cannot be used as a LWCO due to it's location in the boiler; therefore, a
standard well is factory supplied with the unit. If a LWCO device is required, an external
LWCO must be field installed to provide protection against firing with low water levels.
Failure to follow these instructions may result in fire, serious injury or death.
Oil Supply Valve - Always keep the oil supply valve shut off if the burner is shut down
for an extended period of time.
Cold Start Will Void Warranty – Upon power up to the control, increase the LO TEMP
setting to a minimum of 120
start boiler and void the warranty.
2
FOR YOUR SAFETY, READ BEFORE
OPERATING
TO TURN OFF OIL
o
OPERATING_
control system and any oil control which has been
INSTRUCTIONS_
BOILER_
F. Failure to do so will permit the unit to operate as a cold
VS80-130

Advertisement

Table of Contents
loading

Table of Contents