Changing The Sanding Discs - Clarke WOODWORKER CS4-6D Operation & Maintenance Instructions Manual

CHANGING THE SANDING DISCS

WARNING: TURN THE POWER OFF AND REMOVE THE PLUG FROM THE
OUTLET BEFORE CHANGING THE ACCESSORIES.
CAUTION: 'HOOK & LOOP' SANDING DISCS CANNOT BE USED WITH THIS
SANDER!
1. Remove mitre gauge and work
table assembly.
2. Remove the disc guard screws
and disc guard.
3. Remove sanding disc from disc
plate. Sanding discs are attached
to the plate using a pressure-
sensitive adhesive
4. Ensure the disc plate is clean.
5. Peel backing away from the new
sanding disc.
6. Align perimeter of disc with plate
and press disc firmly into position
on plate, leaving no loose edges.
7. Replace the disc guard, disc
guard screws and work table.
CONSUMABLES
Sanding discs are available from your Clarke dealer.
Grit
Fine
Medium
Course
Part number
6502097
6500809
6502102
9