Table of Contents
Advertisement
MITRE GAUGE - DISC SANDER
A mitre gauge can be used on the
work table, as shown. The mitre
gauge head can be set anywhere up
o
to 60
(right or left) by loosening the
lock-knob, setting the mitre gauge
head to the desired angle, and
tightening the lock-knob.
SANDING SMALL SURFACES USING THE MITRE GAUGE
Use of the mitre gauge is recommended for sanding small end surfaces on the
sanding disc.
NOTE: Always move the workpiece across the left side (dust chute end
of machine) of the sanding disc and be sure to hold the
workpiece down tightly onto the table surface.
MAINTENANCE
WARNING: ALWAYS DISCONNECT TOOL FROM POWER SOURCE BEFORE
MAKING ANY ADJUSTMENTS, INSTALLING OR PERFORMING
MAINTAINENCE.
CAUTION: TOOL SERVICE MUST BE PERFORMED ONLY BY QUALIFIED
REPAIR PERSONNEL. SERVICE OR MAINTENANCE PERFORMED BY
UNQUALIFIED PERSONNEL COULD RESULT IN A RISK OF INJURY. WHEN
SERVICING A TOOL, USE ONLY IDENTICAL REPLACEMENT PARTS. FOLLOW
INSTRUCTIONS IN THE MAINTENANCE SECTION OF THIS SERVICE MANUAL.
USE OF UNAUTHORISED PARTS OR FAILURE TO FOLLOW MAINTENANCE
INSTRUCTIONS MAY CREATE A RISK OF ELECTRIC SHOCK OR INJURY.
1. Clean the machine, belt and disc after each use.
2. Keep the machine dry, clean and free from oil and grease.
3. Store the tool in a safe and dry place, out of reach of children.
4. During normal use, sanding belts and disc can become loaded with
sanding debris. Use a stick belt cleaner (available at most hardware stores)
to remove build-up.
14
Advertisement
Table of Contents
