Surface Sanding On The Belt; Sanding Curved Pieces; Sanding Disc; Sanding Outside Curves - Clarke WOODWORKER CS4-6D Operation & Maintenance Instructions Manual

SURFACE SANDING ON THE BELT

When sanding flat broad surfaces on
the belt hold the workpiece firmly on
the surface of the belt and against
the backstop, keeping fingers away
from the sanding belt. Consider using
a push or hold-down stick.
• Use extra caution when sanding
very thin pieces, and when
sanding extra long pieces,
remove the backstop.
NOTE: When using the sander without the backstop, ensure that you you
have a firm hold on the workpiece at all times and take extra
care.
• Apply only enough pressure to allow the sanding belt to remove
material.

SANDING CURVED PIECES

When sanding inside-curves on the
belt sander, always sand on the idler
drum end of the belt.
1. Hold the workpiece firmly, keeping
fingers away from the sanding
belt. Keep the curve pressed firmly
against the idler drum, moving the
work evenly back and forth across
the drum.

SANDING DISC

SANDING OUTSIDE CURVES

Always sand outside curves using the
sanding disc and moving the
workpiece from the left side of centre,
as shown. Keep the curve pressed
firmly against the sanding disc,
moving the work evenly from the left
side of the sanding disc. Be sure to
hold the workpiece firmly against the
surface of the table.
13