Preparation And Use; Fitting The Sanding Disc - Clarke DWS180 Operation & Maintenance Instructions Manual

PREPARATION AND USE

FITTING A SANDING PAD
1. Ensure the sander is switched off
and the plug is removed from the
socket.
2. Remove the sanding disc.
3. Place the allen key in the
hexagon hole in the centre of the
sanding pad and rotate
clockwise to remove disc
4. Place replacement sanding pad and tighten allen key anticlockwise.

FITTING THE SANDING DISC

1. Ensure the sander is switched off
and the plug is removed from the
socket.
2. Select the sanding disc to be
used.
• This MUST be the correct 4 hole
190mm diameter disc with
hook and loop backing.
3. Line up the holes in the disc with those on the sanding pad.
• This is necessary for dust extraction purposes.
4. Press the disc firmly onto the pad to secure it using the hook & loop
backing.
FITTING THE AUXILIARY HANDLE
1. Screw handle into the side of the
sander, as shown.
2. There are equivalent screw holes
on both sides of the sander,
depending on personal grip
preferences.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9