Table of Contents
Advertisement
MAINTENANCE
WARNING: BEFORE PERFORMING ANY MAINTENANCE, SWITCH OFF AND
UNPLUG THE SANDER.
Your sander will operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper care.
Regularly clean the motor ventilation slots using a soft dry brush, cloth or
vacuum cleaner and remove undue buildup of dust from the sander. Do not
use any abrasive or solvent-based cleaner.
A damaged power cable should be replaced by your CLARKE dealer or
qualified electrician.
The bearings in this sander are sealed for life and require no maintenance.
CHANGING THE BELT
1. Disconnect any dust extract hoses
connected to the machine.
2. Remove the lower belt cover by
slackening the six securing screws
sufficiently for the cover to be
slipped off the frame.
3. Tilt the frame assembly up in order
that the belt cover remains away
from the belt.
4. Lock the bed in the upright
position using the locking nut.
5. Release the belt tension locking
knobs and unscrew the belt
adjusting wheels until the belt
goes slack.
The belt may now be slipped off and
replaced by a new one. Drop the
frame back to the horizontal position
and refit the belt guard/cover.
6. Tension the belt by the belt
tension adjusting wheels.
7. Check the belt tracking as previously described on page 12.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
17
Advertisement
Table of Contents
