Changing The Sanding Belt; Changing The Disc - Clarke Woodworker CBS1-5 Operation & Maintenance Instructions Manual

CHANGING THE SANDING BELT

1. Remove the belt table
completely by unscrewing and
removing the table locking lever.
2. Remove the two side cover
securing screws (A), followed by
the upper roller pivot screw (B),
then pull off the side cover.
3. Turn Adjuster (C) anti-clockwise,
sufficiently for the sanding belt to
be slipped off the rollers.
4. Replace the sanding belt ensuring
it is central about the rollers, and
the arrow (D) is pointing down
towards he table.
5. Turn the belt by hand and observe
how it moves on the rollers,
indicated by its position on the
support.
6. This will determine whether or not
it is tracking correctly. If it moves
sideways, turn the adjuster (C), so
that it stabilises over the middle of
the support.
• At this point the belt is tracking
properly. It is tensioned auto-
matically & cannot be adjuste
• Turning the adjuster clockwise will cause the belt to move one
way...turning it anticlockwise and it will have the opposite effect.

CHANGING THE DISC

1. Remove the disc table and lower cover/dust extraction port.
2. Slacken the two screws securing the upper disc cover and slide it back.
3. Using a sharp instrument, tease off a portion of the sanding disc, sufficient
for it to be grasped by hand and peeled off. Remove all residual adhesive
and finally clean the disc with solvent.
4. Peel the backing from the replacement sanding disc and fix to the disc
ensuring it is central. Press it firmly to ensure it is secure.
5. Replace the table and lower disc cover, and adjust gap between table
and disc by positioning and securing the upper disc cover.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
11