Changing The Sanding Belt - Clarke Contractor CBS2 Operation & Maintenance Instructions Manual

PREPARATION
CAUTION: DISCONNECT THE PLUG FROM THE POWER SUPPLY BEFORE
CHANGING THE BELT.

CHANGING THE SANDING BELT

1. Pull out the belt tension lever.
2. Slide the old belt away from the rollers.
3. Slide the new sanding belt into position over the front and rear rollers,
ensuring that the arrows on the sanding belt and on the tool are pointing in
the same direction.
4. Push the sanding belt tension lever back into the recess to apply the
tension.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
7