Operation; Emptying The Grass Bags - Toro 79391 Operator's Manual

12
Installing the Blade (Model
79390 Only)
Parts needed for this procedure:
1 Hi-Lift blade
Procedure
1. Remove the existing mower blade installed on
your mower deck. Refer to the Removing the
Blades section in the Operator's Manual for
more information.
2. Install the Hi-Lift mower blade. Refer to the
Installing the Blades section in the Operator's
Manual for more information.

Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.
WARNING
To avoid personal injury, follow these
procedures:
• Become familiar with all operating and
safety instructions in the Operator's
Manual for the mower before using this
attachment.
• Never remove the discharge tube, bags,
bagger top, or the chute while the engine
is running.
• Always shut the engine off and wait for all
moving parts to stop before clearing an
obstruction from the bagging system.
• Never do maintenance or repairs while the
engine is running.

Emptying the Grass Bags

Be careful when lifting or handling a grass bag that is
full. To empty the grass bags:
1. Park the machine on a level surface and
disengage the blade control switch.
2. Move the motion control levers outward to the
neutral lock position, stop the engine, remove
the key, set the parking brake and wait for
all moving parts to stop before leaving the
operating position.
3. Open (raise) the bagger top
4. Compress debris into the bags. With both
hands, lift up on the bag and unhook it from the
retaining bracket. Empty the bag. Repeat the
procedure for the other bag.
23
(Figure 45).
Figure 45
g005758