Parameter Setting - Siemens SIMATIC S7-1500/ET 200МР Manual

4.2.2

Parameter setting

You specify the properties of the technology module using various parameters. Depending on
the settings, not all parameters are available.
You set the parameters of the module as follows in this operating mode:
1. Insert the module from the hardware catalog under "Technology modules".
2. Set the mode "Position detection for technology object "Motion Control"" and the other
module parameters in the hardware configuration.
3. Insert the axis technology object and, if necessary, the measuring input technology object
from the project tree in folder "Technology objects > Add new object > Motion Control".
You can find information on configuring with axis technology objects in function manual S7-
1500T Motion Control (https://support.industry.siemens.com/cs/ww/en/view/109481326).
4. Open the configuration of the axis technology object, e.g. using the Configuration button
in the respective instruction for the technology object.
5. Set the parameters of the technology objects.
6. Download the project to the CPU.
Note
This operating mode applies automatically to both channels of the technology module.
Parameters of the TM Count 2x24V
The following parameter settings are possible. The default settings of the parameters are
shown in bold in the "Value range" column.
Table 4- 5
Signal type
Invert direction
(counter inputs)
Signal evaluation
for counter inputs
Technology module TM Count 2x24V (6ES7550-1AA01-0AB0)
Equipment Manual, 12/2020, A5E31870371-AC
Programmable parameters
Parameter
•
•
•
•
•
•
•
•
•
•
4.2 Position input for "Motion Control" technology object
Value range
Pulse (A)
Pulse (A) and direction (B)
Count up (A), count down (B)
Incremental encoder (A, B phase-shifted)
Incremental encoder (A, B, N)
Deactivated
Activated
Single
Double
Quadruple
Configuring/address space
Scope
Channel
Channel
Channel
33